Flare is a combustion process through which hydrocarbon gases/VOC's are burned either in open or in enclosed chambers. The primary advantage of flares is that they have high turndown ratios. With this feature they can be used for sudden and unexpected large discharge of hydrocarbons/VOCs such as safety valve discharges as well as venting process setups, non-environment friendly products or waste stream. The main advantage of flares is safe, effective disposal of gases at an affordable cost.

 

Combustion Research Associates is one of the reputed manufacture in design and

development of customized Combustion systems for flares.

 

It is ensured that the destruction efficiency should exceed 98% to meet the EPA

requirements.  Combustion Research Associates is approved by many reputed consultants Govt. agencies for using the systems in the projects.

 

Combustion Research Associates has very wide capabilities to manufacture custom

made flares for incineration of vapours or gases or combination of low or high calorific value. We manufacturer

 

1. Aspirated flare system

2. Air assisted flare system

3. Smoke less flare systems

4. Ground flare systems

5. Skid mounted flare system

6. High and low pressure flares

7. Elevated flare systems

8. Enclosed flare system

 

   ECONOMICALLY PPRICED

 

Combustion Research Associates offers all types of accessories for smooth and safe operation of flare systems. Some of the important accessories are

 

1. Pilot Ignition systems

2. Flame Arresters

3. Microprocessor based control system for flare

4. Moisture separators

5. Knock out drains

6. Flow meters

7. Flame monitoring systems

8. Water seals

9. Moisture separators/Drip traps

10. Pressure Vacuum Relief System

 

Combustion Research Associates offers flares from a very low flow rates to high flow rates.

Capacity - 10-5000 m3/hr. higher or lower capacity can be designed on request.

 

 

The flares are custom designed and the material selection is based on Corrosive

properties, max temperature, thermal shocks, ambient conditions etc. The standard

materials are SS316, SS304, Cast Iron, SS 321, high nickel alloys, Ceramic lining etc.

Other material available on request.

 

 

All type of waste gases and vapours, biogas, producer gas, vapours from dyes, chemical, petrochemical, paper and pulp and other process industries, having combustible waste of low/high calorific value.